If the wet saw s tray moves toward the cutter slowly cut the tile towards the blade and ensuring that the saw is constantly getting sprayed with water from the pump.
Tile saw chipping.
Set your tile on the platform with the mark facing your diamond blade.
A little wobble or slight off centering of the blade to the arbor will create chipping.
As time goes on with cutting the diamonds will wear themselves to adjust to the saw.
Turn the saw on.
Mark the point where you wish to notch.
Turn on the saw push the tile slowly through the blade and get the shallow cut done.
Mark your tile where you want the notch to be.
Guide the saw forward until you cut 1 in 2 5 cm in from the edge.
It just needs a quick sharpening that you can do yourself.
Set your blade to cut all the way through the tile.
You have to be very patient in cutting tiles whether it is a wet saw or a manual tile cutter.
Cut a 1 in 2 5 cm line along your mark with the tile face down.
Fix a piece of masking tape along the mark to make the line easier to follow and help prevent chipping.
If you push the tile too fast towards the cutter you ll increase your chances of chipping the tile.
A great way to avoid chipping on porcelain tiles is to notch the tile before cutting through.
Mark the location of the cut with a marker or pencil.
Make sure the tile doesn t touch the blade before doing this.
If it is a small tile cut only 1 inch in from the.
To make a notch on the end of your tile.
Use a spray bottle to wet the tile with water to reduce dust.
This way you will prevent chipping even more.
Flip your tile over so the finished side faces the bottom of your saw.
Set your blade so that this time it will cut through the whole remaining thickness of the tile.
Set your tile saw blade upon the tile.
Chipping tile when cutting with a saw happens because the blade gets worn.
One way to avoid chipping your porcelain tile is to notch the tile before you cut through it.
Turn on your saw.
Do not touch the blade to the tile.
Follow the below steps to do so.
To notch the tile follow these steps.
After you ve done this you can either cut through the whole tile or cut a notch into one end and then cut the whole tile.
Push the tile into the saw blade approximately 1 or 2 inches depending on the size of the tile then back the tile out and turn off the saw.
Angle grinders and rotary tools are effective ways to cut tile while it s still glued to the wall or floor.
