If the water leaks from the toilet base simply tighten the bolts that fasten your toilet to the floor.
Toilet leaking from base on floor.
If these bolts are loose the toilet may rock breaking the seal formed by the wax ring.
This wax ring seal is positioned between the toilet and the floor.
Remove the toilet old wax ring unscrew the water supply line from the toilet and remove the tee bolts from the floor.
Step 3 remove the two.
Turn off your home s water supply and begin emptying the water from the toilet bowl and the tank.
The leak is going to stop if you are lucky.
Step 2 if you have a 2 piece toilet tank and bowl separate unscrew the water line from the wall then remove the.
Loosen the nut on the supply line that connects the shut off valve to the.
You will need to do this by loosing the bolt.
Check the connection bolts and tighten or replace step 3.
The base of a toilet is held to the floor with two tee bolts threaded up from the mounting ring through holes in the base of the toilet.
Unscrew the caps that cover the bolts with a slotted screwdriver or putty knife.
There may be odor as well from this type of leak.
Locate the water shut off valve under the toilet tank and turn the handle clockwise to shut off the water supply to.
To remove any leftover water unscrew the nut holding the fill valve in place and catch the excess water with a small bucket.
Under every toilet is a large round wax seal.
The toilet s water supply line is leaking the fill valve nut where the water line connects is loose water was not mopped dried up correctly after cleaning the floor the bolts or seal between the floor and base of the toilet are damaged or loose.
Flush the toilet to empty the tank and bowl.
Lastly remove any leftover water from the base of the toilet by plunging it for a few seconds.
Then tighten every bolt alternately with a wrench little by little.
This type of leak can damage the sub floor flooring and possibly the ceilings below the toilet.
How to fix a toilet that is leaking from the base 1.
When a toilet leaks water from the bottom base on the bathroom floor you most likely have a worn out wax ring seal.
If this is the case each time the toilet flushes drain water may seep out around the base of the toilet.
Disconnect the toilet step 4.
It s tough to get rid of.
Remove lift and set the toilet on the floor upside down or on its side.
Remove and replace the wax ring step 5.
Disconnect the water supply line with an appropriate sized wrench.
The water that is leaking out of the base of the toilet is dirty water.
This is to prevent sewer gas and other bad smells from escaping into the bathroom.
Fix you toilet leaking toilet step 1 turn the water to the toilet off and flush the toilet so the tank and bowl are empty.